Washing machines are a fantastic feature. We all hate laundry. However, have you thought about how difficult it is without one? Washing machines are lovely up until the point they’re no longer. Every appliance gets old at some point, including washing machines. Are you looking to purchase a new washer? Have you got one already and need help putting it in it? This tutorial will explain how to set up a washing machine correctly.
Remove the Previous One
The first step in installing a new washer is to get rid of the old model. The first step is to examine your drum inside to ensure it’s empty. Sometimes, the washing machine may block, and you’ll need to empty it before draining it. It isn’t a good idea to shed some clothes or create an accident.
The next step is to switch off the power on the old machine. Then, disconnect the source of energy. Then, pull the washer away from the wall so you can view the valves that supply the water. When you’ve got access to the water valves, cut them off. Use the supply hoses to put them into the bucket, allowing them to rid themselves of all excess water. In the end, unplugging the drain line to your wall is necessary.
After everything has to get disconnected, you’re ready to take the old unit. Washing machines can be bulky and heavy. It can be challenging to move them. Make sure someone is nearby. Take measurements and prepare your new machine before beginning the following steps to describe how to connect to a washer.
Prepare the New Washing Machine
Before you bring the new washer into the room for laundry, you’ll need to determine its dimensions. Be sure that before purchasing the new washer, be sure to measure its dimensions, even the doors. It’s not a good idea to buy a new washing machine and discover that the door can only open partially. If your laundry room is limited, buy a stackable washer, dryer, or even the laundry room.
It would be best if you now examined the floor to ensure it’s level, flat, and tidy. Sometimes, based on the flooring type, it could have had shifts following the removal of an older machine. The next step is removing the bolts at the device’s rear side. These four bolts will stop this drum from moving damaging the engine when shipped.
Before you move the new unit in position, consider putting it on an empty drain pan to avoid damage in the case of an eventual leak. There are leak sensors that function as alarms if they get wet.
Connect the Washer to the Water Supply
The washer must get equipped with brand-new lines for supply. In most cases, these hoses get carried within the machine. After the device has got put installed, it’s time to connect it to the cold and hot lines for water.
Attach the Drain Hose
After you’ve got the water lines, now is the time to connect your drain line. Make use of the pipe reinforcement curve to avoid kinking. Depending on your setup, placing it inside an unfinished drain pipe or sink may be necessary.
Finishing Up
Once everything is connected now that everything’s connected, turn off the water and look for leaks. Make sure to tighten the joints until leakage ceases. Also, set the washing machine at a level, so it does not squeak while washing. It would be best to put an elevated station on top of the device to achieve this. Then, tighten or loosen the locking nuts to reach a good place.
Contact the Pros for Plumbing
At Ottawa Plumbing Service, we are drain and plumbing experts. Our main objective is to offer superior customer service and support. If you want help with your plumbing needs, don’t hesitate to call us at (613) 317-1682 or email us at info@ottawaplumbingservice.com.
