Sump pumps protect properties in the event of water damage. If a storm hits, they remove any excess water accumulated around the property’s foundation, then move the water away. Monitoring and maintaining the sump pump makes sure that it is working as required. It takes about a minute to test a pump and does not require any special knowledge. This article will demonstrate how to test a sump pump’s functionality.
How Do I Test the Sump Pump?
- Once you have located the exit pipe used to drain water from the pump to the outside of the home, it needs to get checked to ensure it’s free of dirt or other debris. Additionally, the pipe must be able to direct the water away from the home’s foundation.
- The debris found in the pump must clear to ensure that the pump does not get blocked. Sump pumps generally get located in the crawlspace or basement close to the foundation’s walls.
- The most effective method for testing the power source is tracing the electrical cables connecting to the pump. The pump cord gets plugged into the side of the float cable plug. Both wires must disconnect, and only the pump cable gets connected to the outlet. When you notice a hum when you turn off the motor, the pump operates. The two wires should secure the same way they did before since all sump pumps have two wires. Here’s a way to test single-corded sump pumps:
1: Around 20 liters of water must be dumped into the pump pit gradually until the float gets raised. The pump should start to turn on. When it’s turned on, the water should pump out, and the pump will shut itself off after getting rid of all water. The sump pump test should repeat to confirm that the device is working.
2: If it gets determined that using the sump pump is not an option, the float must lift, and the pump must examine to confirm that it gets turned on. But, the pump should not run longer than a couple of seconds to avoid damaging the motor.
To Restore Water Damage, Contact Ottawa Plumbing Service Mitigation Experts!
Sump pumps must check every two years before the autumn and spring seasons. If the tests suggested for the sump pump fail, the pump should service immediately. The Ottawa Plumbing Service team stands ready to provide expert restoration services.
Pick Ottawa Plumbing Service for your basement or foundation waterproofing needs. Our plumbers are top in the business and are renowned for their professionalism and friendliness with their jobs. Call Ottawa Plumbing Service at (613) 317-1682 or email us at info@ottawaplumbingservice.com.
