Your dishwasher does its best for you, but occasionally it gets agitated. If your dishwasher can’t drain, many reasons could be the cause. If you are required to repair your appliance, the issue may be in your plumbing, not the device itself. Fix and troubleshoot your dishwasher drainage problems by using these suggestions taken from Ottawa Plumbing Service.
Is the Dishwasher Not Draining? Follow These Steps
Before starting, make sure you are aware that it is normal for dishwashers to leave behind a little water puddle in the base of the bowl following every cycle. If you find a small piece of water left behind, refer to the owner’s manual to find the reason for this design.
Use the Garburator to Run
If the kitchen sink doesn’t flow as well, then the dishwasher will not either. It is because the dishwasher runs into the garburator, which means that a blockage in this area impacts both the sink and the dishwasher. It would be best if you ran the garburator before every cleaning cycle to allow the water to drain.
Remove Any Debris That Has Accumulated from the Filter
The filter can get found in the lower part of the tub beneath the spray arm that is lower or in the rear of the back of your dishwasher. Make sure it gets not blocked with glass, plastic, and food particles. If yes, clean this debris out of the filter. If needed, remove the screws that hold the filter cage in place. Check the inside for any additional waste.
Check the Drain Opening at the Point Where the Dishwasher Joins the Disposal
If you’ve just put in a new garburator, make sure that the plastic plug that covers the drain opening of your dishwasher gets removed. If necessary, take it off using a screwdriver, then remove the plug from the chamber that grinds the garburator.
Look for a Blockage Within the Drain Pipe
Unplug the dishwasher, switch off the circuit breaker, and stop the power supply on the device. Take the toe kick out from the underside of the door to reach the drain pipe. Unclip the clamp, and disconnect the drain pipe from the dishwasher’s pump. Inject air into it to ensure that it’s clean. If it’s blocked, take the clamp at the opposite end and wash the hose clean. It may be necessary to replace the hose if it’s challenging to get rid of the gunk.
Check the Valve Bracket
Most dishwashers have drain valves that stop the water from returning to the appliance. If your dishwasher gets equipped with an insignificant plastic valve bracket, that signifies that it has a drain valve. As the toe kick gets eliminated from your dishwasher, move the underside and push the valve bracket using an instrument such as a screwdriver or pencil to ensure it can move freely. If it’s not moving, it signifies that the solenoid in the electrical circuit that controls it is worn out and must get replaced.
Make Sure to Check for Other Components of the Dishwasher
If you’ve tried the previous solutions, but your dishwasher doesn’t seem to drain, other components could be in the mix, such as your check valve, the pump solenoid, the drainage sump, the door switch, and the electronic control. Tests for these parts require a multimeter and familiarity with electrical circuits. It gets recommended to leave these repairs to experts with the Ottawa Plumbing Service.
Dishwasher Installation and Repair
Ottawa Plumbing Service provides kitchen dishwasher installation, repair, and other plumbing services. If you need help with your dishwasher not draining, please give us a call today at (613) 317-1682 or mail info@ottawaplumbingservice.com.
